DESTILLIERMEISTER E2-4 Supreme

New 2020 model with reduced overall height and longer cooler with reduced water consumption.
Legal, registration-free stainless steel still for essential oils with a full 4 liters of plant space.

20 ml Essenial Oil within 15 Minutes
With over 4 liters of plant space they have plenty of volume to process even larger amounts of plants or drugs. By raising the aroma basket you can also experiment with smaller amounts, but they should then work with reduced heating power. The steam is produced in an extra boiler under the plant container, so that a contact with boiling water can be excluded. The best thing is: Since the kettle is only 2 liters in volume despite the large plant container, the DESTILLIERMEISTER E2-4 Supreme is also legal in Germany and Austria and may be sold and operated without notification.
Simpel handing:

• Pour 1.8 liters of water into the water / steam boiler,
• Place up to 4 liters of plant pipe and close with tension locks,
• Insert aroma basket,
• fill with up to 4 liters of herbs or drugs - do not compress,
• seal as described below
• fit cover 5. and tighten tension locks 4.1,
• insert distillation bridge 6 in socket 5.1,
• screw the coolant hoses to the cooler,
• switch on the heat source and collect oil and Hydrolat at 6.6,
• distill for a maximum of 15 to a maximum of 20 minutes at a higher power (induction plate 2000 watts).

Water / steam tank and plant / drug tube, as well as all distillate leading pipelines are made in high quality stainless steel.

DESTILLIERMEISTER Hobby-E2
Construction of optimized distilleries for over 17 years A registration-free hobby still made of stainless steel. With this beautiful distillery you can make hydrolates, essential oils and distilled water. Easy to use: • approx. Pour 1.7 liters of distilled water into the kettle, • put on the drug basket • fill with herbs or drugs, do not compress, • insert gasket as described below, • put on cover 3. and tighten tension locks 1.1, • insert the distillation bridge 4 into the socket 3.1, • Screw the water hoses to the radiator, connect one end (4.4) to a submersible pump (eg aquarium pump), and the other end (4.5) into the cooling water reservoir. • switch on the heat source and collect at 4.6 hydrolate and oil, • Distill for a maximum of 30 minutes at medium to high heat. The distilling pot and all distillate pipelines are made of stainless steel. The socket for the distillation bridge is made of gunmetal.
The DILLILLIERMEISTER Hobby-E2 is easy to handle. It is ready to use in a few simple steps. For heating, place the distillery on an induction plate. For cooling you need a pot, bucket or bowl of cold water - 10 liters should be enough. With a simple, low-power pump (such as aquarium pump), you can direct water from the reservoir to port 4.4. The hot water leaves the cooling above 4.5. They redirect it back to their water container. Since the cooler is amply sized for its task, a small water flow is sufficient for the cooling.