DESTILLIERMEISTER Hobby-E2
Construction of optimized distilleries for over 10 years A registration-free hobby still made of stainless steel. With this beautiful distillery you can make hydrolates, essential oils and distilled water. Easy to use: • approx. Pour 1.7 liters of distilled water into the kettle, • put on the drug basket • fill with herbs or drugs, do not compress, • insert gasket as described below, • put on cover 3. and tighten tension locks 1.1, • insert the distillation bridge 4 into the socket 3.1, • Screw the water hoses to the radiator, connect one end (4.4) to a submersible pump (eg aquarium pump), and the other end (4.5) into the cooling water reservoir. • switch on the heat source and collect at 4.6 hydrolate and oil, • Distill for a maximum of 30 minutes at medium to high heat. The distilling pot and all distillate pipelines are made of stainless steel. The socket for the distillation bridge is made of gunmetal.
The DILLILLIERMEISTER Hobby-E2 is easy to handle. It is ready to use in a few simple steps. For heating, place the distillery on an induction plate. For cooling you need a pot, bucket or bowl of cold water - 10 liters should be enough. With a simple, low-power pump (such as aquarium pump), you can direct water from the reservoir to port 4.4. The hot water leaves the cooling above 4.5. They redirect it back to their water container. Since the cooler is amply sized for its task, a small water flow is sufficient for the cooling.
Shippingtime:

9 to 14 working days, will be reordered or very long assembly time
(abroad may vary)
EUR 299,00
Shippingtime:

9 to 14 working days, will be reordered or very long assembly time